Tag: Instrument installation
-
Instrumentation Systems Installation: Precautions to Take
Analog systems are normally based on low voltages and as a result, they are vulnerable to electrical noise. In most plants, a PLC may be controlling 415 V high power motors at 100 A, and at the same time, reading thermocouple signals of a few mA. Great care must therefore be taken to avoid interference…
-
Sources of Coherent Interference/Noise in Instrumentation Systems
Introduction The knowledge of how to design low noise instrumentation systems is an essential skill that any practicing instrumentation engineer should strive to learn because noise and interference affects any measurement system in one way or the other and this in turn affects the precision of measurements and the detectability of the quantity of measurement.…
-
Testing, Pre-commissioning & Plant Commissioning Requirements
Introduction A new installation must be fully tested to ensure that the equipment is in full working order prior to its being started. This testing is typically divided into three phases: Pre-Installation Testing This is the testing of each instrument for correct calibration and operation prior to its being installed in the field. Such testing…
-
Instrument Installation – Cabling Guidelines
Instrument installation with the associated cable installation/electrical signal and control wiring should be carried out by skilled personnel who are acquainted with the safety requirements and regulations for the plant site for that specific project. Generally instrument cabling is usually run in multicore cables from the control room to the plant area (either below or…
-
Instrument Installation – Mounting & Accessibility Guidelines
Before we look at the instrument installation – mounting and accessibility guidelines, it is important to ensure that installation is carried out using the best engineering practices by skilled professionals in Instrumentation and Control, Electrical, Industrial Automation, etc. These professionals should be fully conversant with the safety requirements and regulations governing a plant site. Generally…