Tag: Electronic circuits
-
Electronic IC Temperature Sensors
Electronic IC temperature sensors are specialized integrated circuits that are used for sensing temperatures in the -55° C to +150°C range. Basic Principle of IC Temperature Sensors The working principle of IC temperature sensors is based on semiconductor physics. When the temperature of a p-n semiconductor junction changes, the mobility of the charge carriers in…
-
Gunn Diode – Features, Operation & Applications
Features of a Gunn Diode A gunn diode is made up of only N-type semiconductor which is typically sandwiched between two metal conductors. The central section is usually lightly doped N– surrounded by heavily doped N+ layers. The central section is N-gallium arsenide whereas the two outer sections undergo epitaxial growth from GaAs with increased…
-
What Is the Aluminium Layer of a PCB?
Aluminium is among the most important metals on earth. It’s used in various industries and applications, including aircraft parts, furniture, and sporting equipment. However, did you know it’s also used to create aluminium substrate PCBs – one of the most important components of modern electronics? In this post, we’ll discuss the design, function, benefits, and…
-
Frequency Synthesizer – Features, Operation & Applications
Frequency synthesis is a technique of producing a range of frequencies with crystal-controlled stability. A frequency synthesizer uses phase-locked loop (PLL) to generate output frequencies over a wide range. The typical range is from 1 MHz to 160 MHz. As illustrated in the block diagram above, the key components of the frequency synthesizer are: The…
-
Phase-Locked Loops (PLL) – Features, Operation & Applications
Features of a Phase-Locked Loop (PLL) A phase-locked loop (PLL) is a form of a servo system which consists of a phase detector, low-pass filter and voltage controlled-oscillator (VCO) as illustrated in the block diagram below. The phase detector compares the phase of the VCO with the incoming reference signal, giving an output proportional to…
-
Voltage Doubler Circuit Operation
A voltage multiplier is a specialized rectifier circuit capable of producing dc output voltage which is theoretically an integer times the AC peak input, for instance, it is possible to get 200 VDC from a 100 Vpeak AC source using a voltage doubler, 300 VDC using a voltage tripler or 400 VDC using a voltage…
-
Clamper Circuits – Features & Applications
A clamper circuit or dc restorer is used to clamp a peak of a waveform to a specific DC level compared with a capacitive coupled signal which swings about its average DC level (normally 0 V). If the diode is removed from the clamper, it defaults to a simple coupling capacitor – that is, no…
-
Clipper Circuits – Features & Applications
A clipper also referred to as a limiter is a circuit which removes the peak of a waveform. A clipper consists of diodes, resistors and sometimes DC sources to clip or limit the output to a certain level. The input-output characteristics of clipper circuits are typically similar to those of the forward-biased and reverse-biased diode…